It takes some time for ESP to connect to Wi-Fi module. If SSID and password are correct it gets connected to Wi-Fi and if SSID and password are not correct then it will reboot in every 1 second. Serial.begin(115200) //Set Baud Rate to 115200 Serial.println("Booting") // Step to connect ESP with the Wi-Fi WiFi.mode(WIFI_STA) //Set ESP as station mode WiFi.begin(ssid, password) //Wi-Fi Credentials while (WiFi.waitForConnectResult() != WL_CONNECTED) //Connecting ESP to wi-fi takes some time, so wait till it gets connected ESP8266 FIRMWARE UPDATE WHAT BAUD RATE PASSWORD IP address of the ESP is printed on the serial monitor as connecting to the Wi-Fi module. WiFi.localIP() gives the IP address of ESP.Īfter uploading the code successfully open serial monitor at 115200 Baud Rate. ESP8266 FIRMWARE UPDATE WHAT BAUD RATE CODE Press the reset button and after few seconds you will be able to see ESP IP address on the Serial Monitor. ESP8266 FIRMWARE UPDATE WHAT BAUD RATE PCĮSP8266 FIRMWARE UPDATE WHAT BAUD RATE SERIAL.ESP8266 FIRMWARE UPDATE WHAT BAUD RATE PASSWORD.ESP8266 FIRMWARE UPDATE WHAT BAUD RATE CODE.ESP8266 FIRMWARE UPDATE WHAT BAUD RATE SERIAL.
0 kommentar(er)
